3/8/2024 0 Comments Orcaflex mooring analysis![]() For histogram collation, the value is required only if the selected histogram variable depends on the circumferential position within the cross section. This value is not available for mooring and SHEAR7 fatigue, neither of which use $\theta$. A larger number of thetas gives a more comprehensive analysis, but one which takes a little longer. There will be $n$ of these fatigue points uniformly distributed at $360\degree/n$ intervals around the pipe circumference by convention, the symbol $\theta$ (theta) is used to represent their circumferential position, hence the name number of thetas. The number of points around the pipe circumference, at which fatigue analysis will be performed. This facility is not available for histogram collation. ![]() This sets a warning level: if the total damage at any fatigue point exceeds this value, then that damage figure will be highlighted in the results. This bin size is interpreted as having the units of the specified histogram variable. Histograms are presented for equally-spaced bins of the given size. Histogram bin size (histogram collation only) ![]() Histogram variable (histogram collation only)Īs well as the positions on the line to consider, the histograms analysis method must also define the result for which histograms are to be calculated: ![]() The analysis data page contains data specifying the parts of the line to be analysed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |